Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.

Wood & steel frame



Ghost Controls Gate Repair in Laguna Niguel, CA | Ironworks Gate Co.
We repair Ghost Controls gate openers across Laguna Niguel, from the ridgeline tracts off Crown Valley Parkway down to the neighborhoods near Alicia Parkway. The work here is different than it is a few miles inland: salt air, HOA review boards, and thirty-year-old gates on settling hillsides all shape what actually fails. Ironworks Gate Co. is an independent Ghost Controls service provider, not factory-authorized, and we stock Ghost Controls circuit boards, arms, and remotes in our vans so most repairs wrap up in a single visit. Call (442) 246-9347 for a free estimate.
Why Laguna Niguel Residents Choose Us for Ghost Controls Service
Our techs open Ghost Controls units almost every day in Laguna Niguel’s gated communities. That repetition matters. When a Ghost Controls TDS2XP throws an intermittent limit fault or an AXDP starts acting up after a power blink, we’ve usually seen the same failure three times that month. Victor Salinas grew up along the Laguna Canyon Road corridor and learned motor work and metalwork at Saddleback College before spending decades on driveways across South Orange County, so he understands what coastal air does to a control board and what hill slope does to a hinge. We use genuine Ghost Controls replacement parts whenever the supply chain allows, because the opener’s safety and timing logic was built around them. And we’re honest when a fifteen-year-old unit is past saving: if the board, actuator, and transformer are all failing, one new opener costs less than three repair calls. That’s the square deal.
Every job we complete is covered by our 90-Day Done Right Promise, in writing. If something isn’t right, we come back and make it right. No paperwork, no argument. That applies to Ghost Controls work in Laguna Niguel, same as every gate we touch.
Common Ghost Controls Gate Repair Problems We Solve in Laguna Niguel
- Stripped actuator gears on hillside gates. Off Crown Valley Parkway and the ridgeline communities, gates set on sloped driveways settle over decades. The gate leaf drags, the motor strains, and the Ghost Controls actuator gear strips. We reset the post, realign the gate, and replace the gear, not just the symptom.
- Corroded control boards and connectors. Laguna Niguel sits three to five miles from the Dana Point coast, close enough that marine-layer salt air eats at unprotected electronics. We seal replacement Ghost Controls boards with marine-grade silicone so the salt doesn’t kill the next one in two years.
- Remote works, keypad doesn’t after a power outage. This is a Ghost Controls programming quirk we see regularly in Laguna Niguel. The board loses its keypad memory but keeps remote codes. We reprogram it on the spot, usually in under thirty minutes.
- Gate reverses halfway open in the morning. That’s usually condensation from the marine layer shorting a limit-sensor connection, or an obstruction sensor that got fogged. We clean, dry, and seal the sensors, then test the full cycle.
- Slow or jerky gate movement on original 1980s hardware. Many Laguna Niguel homes were built by Avco Community Developers and successors with early electromechanical operators. When a Ghost Controls unit replaced the original decades ago, the posts and hinges may not have been updated. We handle the realignment, hinge replacements, and motor work together.
Ghost Controls Service in Laguna Niguel: What Local Conditions Mean for Your Equipment
Laguna Niguel was built as a master-planned community from the late 1970s through the 1990s, and that fact shapes nearly every Ghost Controls repair call we take here. The original gates and operators, many of them now thirty to forty years old, are reaching end of life on nearly the same schedule across whole tracts. But the bigger wrinkle is the HOA layer. In most Laguna Niguel neighborhoods, any visible gate hardware change requires architectural review before the work begins. We coordinate that review on Ghost Controls motor and panel replacements, matching the original wrought-iron aesthetic the 1980s developers specified. That step is routine in Laguna Niguel and almost nonexistent across the Lake Forest line. Skipping it can mean a stop-work order, which nobody wants halfway through Gate Repair in Laguna Niguel. We handle the paperwork before the first bolt turns.
Ghost Controls Models & Products We Service in Laguna Niguel
We work on the full Ghost Controls residential lineup: the TDS2XP heavy-duty dual swing opener, the AXDP dual gate opener with battery backup, the R20 single swing opener, and the DEP2 dual swing kit. Most of our Laguna Niguel service vans carry Ghost Controls circuit boards, actuator arms, and remote kits, so we typically don’t need to order parts and come back a second day. When a genuine Ghost Controls part is backordered and a homeowner needs the gate working this week, we will install a quality aftermarket board or arm and tell you exactly why we made that call. No surprises.
We also handle motor installation, gate realignment, and remote control programming as standalone services, not just as add-ons to a repair. And if you’re weighing repair against replacement on an older Ghost Controls unit, we’ll give you a straight comparison in plain numbers so you can decide with your head, not a hunch.
Ghost Controls Service Pricing in Laguna Niguel
| Service | Typical Range |
|---|---|
| Ghost Controls diagnostic / service call | $89 - $129 |
| Control board replacement | $180 - $320 |
| Actuator arm or gear replacement | $200 - $380 |
| Limit switch reprogramming | $75 - $150 |
| Full Ghost Controls opener installation | $900 - $2,400 (unit + labor) |
Your final price depends on the model, the condition of the posts, and whether HOA coordination adds time. We quote the work before anything starts, in writing, and that’s the number on the bill. No add-ons at the end. Call (442) 246-9347 for a free estimate on your Ghost Controls repair in Laguna Niguel.
Serving Laguna Niguel, CA - Our Local Coverage Area
We’re based in the Laguna Niguel area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Ghost Controls Gate Repair in Laguna Niguel
The control board dropped its keypad memory but kept the remote codes, which is a common Ghost Controls behavior after a power interruption. We reprogram the keypad on site, usually in under thirty minutes, and test it against all stored remotes. Call (442) 246-9347 and we can walk you through it or schedule the visit.
Yes. We install genuine Ghost Controls boards whenever they’re available, but if the part is backordered and your gate needs to work now, we’ll put in a quality aftermarket board, tell you what we used and why, and get the gate running the same week. Estimates are free at (442) 246-9347.
In Laguna Niguel, that pattern is almost always marine-layer condensation on the obstruction or limit sensors. The moisture shorts the signal, the board reads an obstruction, and the gate reverses. We clean, dry, and seal the sensor housings so the behavior stops, not just for one morning.
Usually the motor is fine. Rain softens the soil, a post settles, and the gate leaf starts scraping where it didn’t before. We reset the post, realign the gate, and recheck the opener’s limits. If the Ghost Controls actuator gear was damaged from the added strain, we replace that too. Call (442) 246-9347 and we’ll tell you what the gate actually needs.
Yes, and this is a common request in Laguna Niguel’s HOA-governed neighborhoods. We prepare the architectural review submittal so the opener and any visible hardware match the community’s design standards, then handle our Gate Installation in Laguna Niguel once the approval clears. We handle the whole thing, start to finish.
Service Areas Near Laguna Niguel
We serve Laguna Niguel and the nearby communities: Ghost Controls service in Aliso Viejo, Ghost Controls service in Laguna Beach, plus Laguna Hills, Laguna Woods, Ladera Ranch, and the surrounding neighborhoods. If you’re in the Laguna Niguel service area and your Ghost Controls opener is acting up, we’ll get to you. For the broader scope of what we do on this brand, see our Ghost Controls sales & service page.
Book Your Ghost Controls Service in Laguna Niguel Today
Call (442) 246-9347 for a free estimate on your Ghost Controls repair. A live person answers, day or night, and we’ll get your gate working right. We fix it right the first time, or we come back - simple as that.
Written by Victor Salinas, Owner at Ironworks Gate Co., serving Laguna Niguel since 1984.
Before
After
Before
After
Before
After